Case neck turner??

[Crumster]

I have always used a simple Sinclair tool. Chuck the case up in my drill press, true it while spinning then stop and tighten the chuck and proceed. I'm thinking there must be a better, easier way. Hornady, RCBS, etc?

 

[Straightshooter1]

I have always used a simple Sinclair tool. Chuck the case up in my drill press, true it while spinning then stop and tighten the chuck and proceed. I'm thinking there must be a better, easier way. Hornady, RCBS, etc?

How about just holding the Sinclair neck turning tool in your hand and use a case holder, like the Sinclair case holder, mounted in a cordless drill? Using this combination works quite well for me and its easy and fast.

 

[Big Mc]

I have always used a simple Sinclair tool. Chuck the case up in my drill press, true it while spinning then stop and tighten the chuck and proceed. I'm thinking there must be a better, easier way. Hornady, RCBS, etc?

Look into the 21 Century tool. You can thank me later. Tommy Mc

 

[Tesoro]

K&M carbide with ergo handle and pilot w/reamer tip. And case holder with the donut wheel and some non skid tape.

 

[Crumster]

K&M carbide with ergo handle and pilot w/reamer tip. And case holder with the donut wheel and some non skid tape.

Thanks. I for the 21 Century right off the bat. Thanks again.

 

[Crumster]

Look into the 21 Century tool. You can thank me later. Tommy Mc

OK, it's later and I'm thanking you. Impossible not to like their little $119 neck turner. In my benchrest days I probably would have gone big time, but all I shoot these days have four legs buck teeth.