case holders for neck turning

[milboltnut]

anybody have them? I edited the title and post itself

http://www.xxicsi.com/case-holder-and-drivers.html

 

[david kieffer]

for this to come along.

http://www.xxicsi.com/case-holder-and-drivers.html

You must have taken a VERY LONG NAP . I have had this since ??? I am to old to remember . They are very handy , you will enjoy . shoot small dave

 

[457ciSBC]

Years back Darrell Holland used to sell something similar.

 

[Bill Norris]

Sinclair has been selling those for a good while too.

 

[ronemus]

Sinclair has been selling those for a good while too.

+1 - I've been using them for over 15 years, and they weren't new when I got mone.

 

[milboltnut]

LOL well I guess I just wasn't looking hard enough... did a general search but just didn't word it right. I think I gave up when I found a plastic adapter to hold a Lee shell holder to make it easier to release thier trim unit.

 

[milboltnut]

Ok...update. I thought it looked like a quick snap in holder, but you have to thread in and out to hold and release the case. Not what I want.. Lee is the same thing, threaded.

 

[Downhill]

I have run the Lee longer than I can remember. Even wore out the cutter. Simple and relatively quick.

 

[milboltnut]

guess a quick snap in wouldn't secure the case enough. Lee is too small and cumbersome. The one I listed looks nice. I saw Horandy neck trimming tool. Looks like a great tool.

 

[david kieffer]

I have and use many brands of these case drivers . Yes you want , need one or ten also . My two favorites are the 21st century and pma tool , the sinclair is my leased used . Don't let the screw in and out scare you they are quick and easy to use .

 

[milboltnut]

I have and use many brands of these case drivers . Yes you want , need one or ten also . My two favorites are the 21st century and pma tool , the sinclair is my leased used . Don't let the screw in and out scare you they are quick and easy to use .

Ok... it looks like it's easier than Lee, and the center detent? secures in the primer pocket better? I'm looking into utilizing my Forester neck turner in my vice with a power screwdriver or drill.

 

[skeeljc]

I just use the collet chuck on my lathe.

 

[jackson1]

I use my disassembled K&M case holder and a hole shooter. Can use Lee inserts with it. Many ways to skin the cat.

 

[FNSafari]

I've used a Sinclair, now Brownells, for years. Good gadget!

 

[Dusty Stevens]

Dont forget pma tool in your search. 21st century, k&m tool or pma tool are the only ones to have

 

[milboltnut]

21st looks the best, k&m 2nd

 

[Dusty Stevens]

The main difference being the shellholder. One driver or a different one for each case.

 

[KMart]

I just use the collet chuck on my lathe.

For any case less than 1/2" in diameter, I chuck it up in my 1/2" battery powered drill.

 

[Dusty Stevens]

I just use the collet chuck on my lathe.

What about those pesky tapered cases?

 

[skeeljc]

What about those pesky tapered cases?

The part that fits into the bolt is not tapered (well maybe .001 between the rim and the body on a .223). All I know is it works (.223 Rem in a 3/8" collet).