Can you make me some bushings ?

[zap]

I am looking for someone with a lathe to make me 8 small bushings, for my 2 gravely rider tractors.( sorry not gun related).
They are for the front wheel assemblies, so the bearings are close to these bushings, i think before and after the bearing races.
The sizes are , id - . 752. , ( this is the most critical dimension, as these will slip over the shaft which must be .750. I will measure the shafts just to make sure they dont have any wear on them.)

OD - 1.00
Length - .50

So again, the size is : I.D. .752
O.D. 1.00
Length. .50

I need a total of 8 of these made. It looks like they use a softer steel as to not wear the shaft, and bearings, so something like cold rolled steel may work ?

If this is something that you could make me, let me know with a quote. Im sure they could ship in a small box or a small Post office box for under $10.00 to ship, which i will pay as well as what your quote is.
Please let me know by sending me a pm.
Thank you,
Lee

 

[Ramblerman]

Pm sent.

 

[zap]

All PM’s answered.
Thank you fellas !!

 

[gunsandgunsmithing]

Looks simple enough but is this a wearable bushing or more of a spacer. From the diagram, I'd guess itjust takes up space against the inner bearing races.

 

[TAJ45]

Mike, I'd bet you are correct. The pcs he needs fit air radially and two thou is too much for a shaft fit imo. The race and brg are the, well, Bearing surface. I doubt if .003-5" over would hurt a thing and I'm a picky so and so for fits.
Just break the I.D. edges.
If the id was determined with calipers it will be a smidge larger from the rip.