Bushing bolt

[butchlambert]

Toolpost grinder. Just a way of saying .059 to .060. --Jerry

Way it was posted you were going to grind the .059 to .0595. I use my surface grinder in a spin collett, but mine get smaller.

 

[4xforfun]

I just measured his firing pin....... .082ish.

Asked and answered!! Will send to GreTan on Monday.

Thanks Guys,
Tod

 

[forsyth793]

I just measured his firing pin....... .082ish.

Asked and answered!! Will send to GreTan on Monday.

Thanks Guys,
Tod

When You send it to GreTan inquire about their fluted firing pin assembly.

 

[Alex Wheeler]

Inquire all you like, so long as you dont put that fluted pin in your bolt.

 

[carlsbad]

Just happened to be bushing a bolt for a friend at the range today. This is what it looks like. Don't have a handy photo of a full sized pin. this is a 223 BF so normally the pin looks oversized in the small bf.



View attachment 1020526

 

[Eric Leonard]

some fired cases all with same load,,130 VLDs and H4350,,pretty stout but the brass on left has 25+ reloads and still hold primers good and tight,

left 2 cases from Tac 30 action
middle 2 from factory R700
right 2 from same R700 after Greg Tannel bushed the bolt and turned the factory pin to .062