Bullet seat too deep. Do Hornady bullet puller or RCBS fits on Lee precision press?

[Old Tanker]

Do yourself a favor and at least look at this https://grip-n-pull.com/,
I have tried them all and IMO this is the easiest and best so far.

I like the grip and pull but don’t know if it will work for the OP. Looks like it would be difficult to get a good purchase below the ogive.

 

[Coyotefurharvester]

Hopefully you are using Hornady bullet #30395(30-30 bullet). Hornady #30396 is for the 308 express. I would use the hammer type puller and give 2 firm raps and check to see if the cannelure becomes visible, if it does set up for a light crimp and then shoot away. If you loaded with the express bullet, that cannelure and bullet shape(ogive location) is very different.

 

[divingin]

Put a foam earplug in the bottom of the puller and the bullet won't be damaged.

I used a strip of 1/4" wetsuit material rolled into a ring and shoved in (might have been a couple; don't remember now.)

You still end up with powder all over the place though.

 

[ChesterS]

The hammer type worked well for me. Pulled as many as 200 one time. The clamshell inserts they use are a pain. I found that the RCBS shell holders work well with the Frankford Arsenal one.

 

[Davidb187]

Je suis du Québec aussi. J'habite près de Trois-Rivières. Si jamais tu as des question je viens sur le forum 2-3 fois par semaine, juste a envoyer 1 message en privé.