• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Browning X-Bolt 2 and Timney Trigger

Trying to determine the area of a Browning XB2 Speed OVS stock to Dremel that will allow Timney trigger and safety to work. Installed and already used Dremel to some degree but safety will not engage when stock is tightened down. Safety move fwd/bck with ease until stock is tightened down. Factory trigger reinstaleld and works fine. Range and accuracy still good... but factory trigger pull is just a bit too high for me.

Do I need to Dremel underneath the trigger? Help!
 
I ran into this sane issue on a older xbolt. This is a heavy rifle and i olny shoot it from a bench and never fixed it. I know its binding in the stock but never looked into it.
 
If you think it's not touching anything It may be a bedding issue causing the trigger to bind up. I've seen it many times.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,905
Messages
2,225,177
Members
80,047
Latest member
Thisisdenny
Back
Top