• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Brass not stretching in chamber

New lapua 30-06 measures 2.004
2 × fired measures 2.0045, 2.0050
Only grabbed 2 pieces out of tumbler.
I do neck size only w rcbs fo die backed out 1 full turn.
How's the bolt feel? Are you getting close.
 
How's the bolt feel? Are you getting close.
Butter no lift issues or tightness.
RPbrass I was running 55.8 gr h4350 light cratering but no other issues on that load.
Shooting OCW test today i went as high as 56.2 and no cratering but groups were in the
.4's up from low .3's with the Rp brass.
Next I'll test at 56.2 to 56.8 in .1 increments
and see what happens
Edit RP brass was 2grains heavier than the lapua
 
I've started ordering case gauges from Wilson, my 6 br is a bit tricky for what reason but the 308 is right on. Answered my chamber questions. And as long as I'm within the headspace groove I'm good to go.
These sound good but are they at samii speck? I would like to only bump .002 if I could
 
I set mine for .0025 headspace
I buy them at Brunos $23

At that price think x Mas Stocking stuffer :)
So with this gauge I can keep firing until the cases get to max on gauge then set my dies ? This probably sounds stupid but I'm trying to get this clear in my mined ,to much coffee this morning
 
This is one of several things I learned from Guffey as well as using a feeler gauge under the shell holder to adjust my Dies bye way of threads.
This sounds like a great Idea, so to get it right you stick feeler gauges under shell holder run Ram to top and adjust die down to touch shell holder?
 
I start about.010 feeler take a measurement then adjust accordingly
Guffey told me I wasn't cut out to be a reloader.
I would read his post then go to the shop and kick the wall first, then get out the feeler gauge and start measuring"
SOB taught me something after all!
Skip's Die Shims don't put me to the curb......
 
I have no issues with .002" in head clearance across loaded cases when fired. That's how far the case head is from the bolt face when the firing pin drives the case full forward in the chamber against its headspacing point; rim, belt or shoulder.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,791
Messages
2,224,025
Members
79,861
Latest member
srak
Back
Top