Brass Drying Rack - 3D Printed

[jlow]

Hey jlow, thanks for the suggestions. The inside is actually hollow and the side facing the fan is open to force air up through the case. The pillars are also hollow and perforated.

Ha! Nice job! Great minds think alike!

 

[savagedasher]

I have no idea why you would get cases wet to begin with.
I have cases I have loaded for years and all they have seen is a viborator . Larry

 

[jlow]

I have no idea why you would get cases wet to begin with.
I have cases I have loaded for years and all they have seen is a viborator . Larry

Hmmm... I could say something but just biting my tongue like crazy right now....

 

[savagedasher]

Hmmm... I could say something but just biting my tongue like crazy right now....

Bite it doesn't let me stop you.

 

[jlow]

Bite it doesn't let me stop you.

It was just such a perfect setup to not say anything....... I'll just have to settle for sticking it out!

 

[savagedasher]

It was just such a perfect setup to not say anything....... I'll just have to settle for sticking it out!

Last time I did mine it hurt .

 

[rmist]

It's still a cool tech in this new age of gadgets.
When wet tumble I dry by a towel then finish with annealling!!

 

[Mark Johnson]

I use a couple of these. About 100 rounds per patch. They also fit inside the Hornady hot tub so I can clean on the rack.

https://www.amazon.com/dp/B00HDCGA0M/?tag=accuratescom-20