• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Bolt/ Firing pin maintenance & care

Why would it be more? Over time the spring force should degrade not go up? Thanks for the feedback Alex.
Dave
It wouldnt go up over time but it may have started there. Springs are not all the same. Just because its supposed to be a 21 pound spring doesnt mean it will be. This is a very critical part of the ignition and plays a big role in accuracy
 
I have a spring tester, basicly an oversived arbor press with a push/pull gauge, but a scale like dusty said will get you close
I've used a spring tester for automotive valve springs and assume it's like that. It's like an arbor press also. Is your spring tester based on a set amout of travel or based on a certain compression height? I haven't seen one used?
 
Is the spring poundage measured at installed length, cocked or fired length?
The following analogy is from my drag racing years so bear with me. The spring rate defines the characteristics of the spring as purchased. It is determined by the material, the diameter of the materiel and the number of turns per inch. It is calculated by the change of the measured force divided by the amount of change in the compression length equal rate. With that number you can calculate what the pressure will be at a given installed length. It will let you determine if and how much you need to cut fron a spring to get it to do what you want. Typically all else equal a spring with more turns will have a lower rate than one with more turns because each coil will compress less when compressed the same amount. BTW when I measure the rate of a spring I get my numbers close to the installed height that I intend to use.
Now my question is what do the #21, #25 lb that everybody uses refer to?
 
Those of you pushing a spring down on a scale to get the weight, have a measurement ? I was thinking in terms of 1/4 inch push or something in that line of thinking?
 
Borden recommends changing spring every 5,000 rounds. I always let the pressure off the spring before putting rifles in the safe.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,884
Messages
2,205,469
Members
79,189
Latest member
Kydama1337
Back
Top