Best inside neck chamfer tool

[kev77]

Who makes the best inside neck champering tool. Thanks in advance.

 

[Sandstorm]

The Lyman VLD chamfer tool..is my fav

 

[Fuj]

I made my own from a carbide burr, and it's about the same
as the Sinclair VLD hand carbide model.

 

[Martin52]

+1 on the Lyman VLD.

 

[Mike Samer]

I have the Lyman VLD, but K&M has one with a depth stop that looks pretty neat.

 

[bulaman]

I use and really like the K&M tool. It has a pin that goes through the primer hole to keep it in alignment and is easy to set for depth of chamfer to keep the chamfer a consistent depth from case to case.

 

[J.d. Popkes]

Henderson

 

[Ripa]

The one that stays sharp forever and never ever leaves any burr, read carbide

 

[JayHHI6818]

Sinclair carbide chamfer is awesome! I bought one last year and is the Smoothest cutting one I have ever used

All SINCLAIR INTERNATIONAL Products for Sale Online - 236 Products

Brownells has 236 SINCLAIR INTERNATIONAL products for Sale Up To 91% Off including Reloading, Tools & Cleaning, and Gear.

www.sinclairintl.com

 

[6bra1k]

i am seconding the k&m adjustable...but it is case specific on the adjustment, so for general use lyman ..think it is a vld

 

[jackson1]

Wilson, in conjunction with their case trimmer.

 

[Dogsmack]

+1 on the K&M. Consistency is the name of the game

 

[Rook 6]

+2 on Lyman VLD

 

[Clancy]

Lyman VLD screws into the small RCBS handles, good combo

 

[agr516]

Wilson, in conjunction with their case trimmer.

What is your trick to keeping the trimmer aligned with the case? I got bad results using my Wilson trimmer because the OD of the case holders was not consistent. I went back to using a handheld RCBS "rocket ship" tool

 

[Walt Krafft]

Taper pin reamers

 

[jackson1]

What is your trick to keeping the trimmer aligned with the case? I got bad results using my Wilson trimmer because the OD of the case holders was not consistent. I went back to using a handheld RCBS "rocket ship" tool

I slide the cutting tool out and install the chamfering tool. Never removing the brass from the holder.

 

[RegionRat]

This style is unique to K&M as far as I know. The long pin aligns the tool to the primer flash hole. Those flat fingers are fixed to the handle and index against the case mouth to control the depth. The cutting tool is adjusted by a thread inside the handle and then locked in place with the set screw. If you like, you can mount it on a powered station or drive it from threads in the handle.

I only use this when I am being very picky. Carbide VLD style tools are not hard to find and can occupy a station on a motorized case prep center for work when you don't run a three way cutter, which is what I run most of the time.

 

[WSnyder]

Made my own and prefer them over others. I have a K&M and a Holland but don't use them much if ever anymore. The newer K&M looks much improved over the original that I have.


Previous discussion here:

Darrell Holland Chamfer tool reviews?

Looking for a good chamfer tool. I know about the KM. I had one and it is obviously nicely I saw the. Darrell Holland. Seems like a nice design and is one of a few on the market that is carbide. Any thoughts...

forum.accurateshooter.com

 

[Capt. Oblivious]

I prefer my good old Forster 3in1s