Best Custom Full Length Dies

[Preacher]

Who makes the best custom full length sizing dies today, either in a inline or screw in ????

 

[steveyrock]

Hi Preach

I have gotten some good costum dies in the past from Neil Jones.

http://www.neiljones.com/

I have one of Harrels full lenght dies that takes the Wilson bushings for my PPC and a costum cut neck full lenght die for my 6BR from Forster,the neck was cut, by them at .259 for a .264 chamber.
I also have the Forster micrometer seating die which gives very good loaded rounds.

 

[chino1969]

I've had Jim Carstensen,JLC Precision) convert small base sizing dies to accept bushings. Send him three pieces of fireformed brass and the die and you'll get a perfectly sized die that will bump your shoulder, size the neck to the bushing size, and minimally size the case. I've used Redding small base body dies in 6mmBr, .308, & .223 with very good results.
Chino69

 

[vmthtr]

I used the Newlon die blanks and had my Gunsmith ream them with a sizing die reamer made at the same time as the chamber reamer.

Mike

 

[BountyHunter]

Neil Jones.

He is the only maker of the FL with shoulder bump bushing that I know of. Also he can make them off your reamer print. He usually sends you a neck size only to work with for 3x firings and then you send 3 cases fired 3x and the neck die back and he makes a custom body insert for the FL die.

My 6BR DX die is going back to him tomorrow for the insert.

BH