Bedding to a Picatinny Rail

[rckendall]

Does anyone have any experience with bedding an attachment to a picatinny rail? I have a piece nearly completed that I would like to attach to a rail and be able to remove it later if my plans change. My intent would be to use fasteners to hold it in place.

I have worked with epoxy quite a bit (West Systems) and normally use wax paper when I want the part to release. With no draft angles I'm afraid anything I bed/mold in place won't release.

I also have and use Devcon plastic steel(?), but I think the release agent will be the key to any success.

Thanks in advance,
Richard

 

[Dusty Stevens]

May try a cheaper rail to try it out like an egw then if it works do it on the other

 

[Kings X]

Spray the rail with Pam. Leave the attachment dry so that epoxy sticks to it. Be sure to spray the screws also.
Any problem -add heat to get them lose