I have spent hours pouring over the numerous posts and I am thankful for all of the knowledge and advice out there. As a newbie this information has helped considerably as I start this bedding project. I recently acquired a new CZ 550 American chambered in .22-250 with walnut stock as I couldn't resist the deal. My problem stems from dealing with a detachable magazine leaving little to bed? The tang is also finished with the 'jagged edge' surface. Does this need to be milled prior to bedding that area, or will a solid pillar job at tang screw with no bedding be the way to go? Any thoughts or theories are greatly appreciated!
Bedding CZ550 American question
- Thread starter ben_dover
- Start date
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.