BAT B stock to Rem700

[Pinkes]

Hi.
I have 2 Bat model B laminated stocks that I don’t use. I am wondering if I can reuse them to fit a Rem700 SA and Rem700 LA? What will I need to change for it to work?

Regards
D

 

[LVLAaron]

Depends on the stock. I've done a handful of stock "reworks" like that. One of my own was a right hand savage repeater, to a left hand single shot 700. Essentially, fill the holes and spots you don't need, and make new ones where you need them.

BR stocks made for a big tang aren't the same as a rem stock... but it can work.

 

[Sniperhandle]

Get some Devcon 10110 and go to work.

 

[LVLAaron]

Anything is possible with enough resin, files, and patience.

 

[LVLAaron]

Sorry to hijack - Filling the barrel channel to fit the current barrel. Lot of faith in my release agent for this one

 

[jackieschmidt]

If aesthetics are not your main concern, you can rebed just about anything.

I have one old Robertson Stoch that has probably had four different action makes in it.

Like was said before. Devcon is your friend.

 

[boltfluter]

View attachment 1670074View attachment 1670075

Anything is possible with enough resin, files, and patience.

That's a nice job where the floor plate used to be. Looks like fiberglass cloth and resin?
Paul

 

[LVLAaron]

That's a nice job where the floor plate used to be. Looks like fiberglass cloth and resin?
Paul

Resin and chopped fiber. Needed 2-3 "lifts" to fill it up, but it works!

 

[turkeynut]

View attachment 1670161


Sorry to hijack - Filling the barrel channel to fit the current barrel. Lot of faith in my release agent for this one

What did you use to fill the channel?

 

[LVLAaron]

Total Boat resin and micro balloons. The top edge came out a little rough, so I gooped some JB Weld along the edge and then block sanded it flat.

One can of duracoat later: