Barrel thread identifying

[Cory porter]

I purchased a rifle as well as barrels that were on hand and am realizing there looks to be 3 different thread pitches

I was under the impression they were all for a Bat rifle, any help would be appreciated. I don’t have an action wrench to break the current barrel on the gun up to match yet

 

[Kurz]

You can use one of these along with your calipers for diameter. There are metric and inch:

Threads per Inch and Thread Pitch Identifiers​

https://www.walmart.com/ip/Thread-G...ent-Checker-Meas/1289445718?classType=REGULAR

You can also look up each action to get the action thread form.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[brcman]

The bottom three in the photo are likely for a early model DAT DS, I have early BAT DS's and these actions were not threaded the complete length due to there being a bronze insert at the front end of the actions. On these early actions a barrel could be threaded all the way or as those three in your photo.

 

[Aaron23]

I purchased a rifle as well as barrels that were on hand and

Looks to me like you scored big time!

 

[Cory porter]

Looks to me like you scored big time!

Gotta figure out what they are first, assuming they are all for a bat I’ll never have to buy a ppc barrel again

 

[Aaron23]

Gotta figure out what they are first, assuming they are all for a bat I’ll never have to buy a ppc barrel again

No.

This means you may need to possibly build more rifles to put those other barrels in.

You got more rifles now and that is good...