liseo
Silver $$ Contributor
Hi
As I have no experience in making the lead barrel slug, I thought of using the bushings(tight fit) at the end of the cleaning rod and gently pushing through the barrel to feel any point that offered more resistance. The barrel was well lubricated with thick oil.
I decided to do this and noticed that at some points (every 3 inches)the cleaning rod was heavier to pass through the barrel.
It can be considered a valid method for checking uniformity?
what do you think?
Thanks
***A posted this on another forum, but seems nobody will answer...hope I have more luck here....
As I have no experience in making the lead barrel slug, I thought of using the bushings(tight fit) at the end of the cleaning rod and gently pushing through the barrel to feel any point that offered more resistance. The barrel was well lubricated with thick oil.
I decided to do this and noticed that at some points (every 3 inches)the cleaning rod was heavier to pass through the barrel.
It can be considered a valid method for checking uniformity?
what do you think?
Thanks
***A posted this on another forum, but seems nobody will answer...hope I have more luck here....