Barrel marking

[rdb8847]

Best way to stamp or etch chamber info on pre fit barrels that are not stamped already?

Thanks
Roger

 

[Judd]

Laser engraver
Etcher
Pantograph
Punches

You could flip the middle two but I don’t think anyone would argue the top and bottom.

 

[scasa]

You can make an etcher with an old wall wart and a couple of alligator clips, salt water, and Q tips.
the hard part is the stencils . I got mine from the local print shop where they make vinyl signs . they were cut out on a cutter that's like a cnc exacto knife. Peal and stick.

 

[BuffaloBill]

I bought this $1500 20W fiber laser a while back and find it marks barrels just fine.

ComMarker B4 Laser Engraver Is An Affordable 20W Fiber Laser With Outstanding Performance! - ComMarker

Just a few years ago, a fiber laser engraver was something that cost tens of thousands of dollars and only just big companies could afford these wonderful

commarker.com

 

[hogpatrol]

Some jewelers can do a decent job. Same goes for trophy shops.

 

[Bob3700]

Local trophy shop has a laser in graver n does a great job.

 

[rdb8847]

Thank you for the great ideas!!! I’m going to first try a local trophy shop.