Barnes match burner 105 BT

[Will o]

Hi any one tried these in 6 mm br with the shortage of Berger bullets in Europe I have being offer some to try and info welcome

 

[bks22345]

I’ve shot the 120s in a 6.5 Grendel and the 140s in a 6.5CM. I had some loads that worked really well and then they wouldn’t. I bought some 147s and the base to ogive varied as much as 0.013. The weight varied too but I don’t remember the spread. I sorted them by weight and BTO but was not able to develop a load that would group better than 1,5”. I moved to the 142 SMKs and haven’t looked back. They may work for you but with the cost of components I’m done with them.

 

[65WSM]

I bought a couple of boxes for a benchrest 6mm Dasher. The points were all unique. Lots of bents and dents. Hollow points were highly variable in diameter. I would not purchase these again.

 

[762willdo]

I have a partial box sitting on my shelf………

 

[SecondsCount]

I have experience with them in a 8 twist 6BR.
5 shot groups are between 0.3-0.5 MOA, which is good enough for the kind of shooting that I do.

Also try the Nosler 105 RDF if you can find it. I like how it shoots at longer distances.

 

[6Creed73]

I'm currently doing load development with these for 6CM and I'm struggling to get decent groups. Feel like I already wasted enough components and may just put the rest of these at the back of the shelf.

Today I did some seating depth ladder testing and got frustrated and quit for the day. I started on the lands and went all the way down to 0.075 off the lands in 0.005 increments and left with nothing to write home about.

 

[urbanrifleman]

The 112s hammer.