Well, in so much as 3 + 4 = 7
Just something I tried - and it seems to be working (almost).
The V4 is great, but struggles with fine pistol powder. I used to use my V3's trickler when I loaded pistol, but switching between the two means moving the scale, and I really only need the trickler part, and only when I want to load pistol...
So, I got a small Serial switch device so I can keep both connected at the same time (only one is powered at a time of course).
I am picking up slight scale drift with this setup ( which I never saw before), but I did remove my scale power from the UPS I usually power it from, so not sure if that is the cause. The switch doesn't have any electronics or external power, so I doubt that it is the cause.
Anyway, I will be putting it back on the UPS and see if the drift goes away.
Just something I tried - and it seems to be working (almost).
The V4 is great, but struggles with fine pistol powder. I used to use my V3's trickler when I loaded pistol, but switching between the two means moving the scale, and I really only need the trickler part, and only when I want to load pistol...
So, I got a small Serial switch device so I can keep both connected at the same time (only one is powered at a time of course).
I am picking up slight scale drift with this setup ( which I never saw before), but I did remove my scale power from the UPS I usually power it from, so not sure if that is the cause. The switch doesn't have any electronics or external power, so I doubt that it is the cause.
Anyway, I will be putting it back on the UPS and see if the drift goes away.