JustDreaming
Gold $$ Contributor
Hey all,
Just finished up a new version for the AutoTrickler V4, if anyone is interested.
-------------------------------------
Update: I've done a minor tweak to the risers (thx for the idea Lawrence97) and have included an nylon adjustment thumb screw in the rear wing to allow tilt adjustment for your ATv4 trickler. While I do include a rubber bumper on the rear, you can pop this off. This should help prevent the need for shimming the unit to adjust the feed flow from the smaller trickler tube as mentioned in the manual.
Additionally, with some powders, I find that is your are using the Area 419 cup, the powder granules can sometime bounce out. I've worked up a little extension to push into the factory power nozzle that will help prevent that.
-------------------------------------
This version will only come as a enclosed version with removable doors like the V3 version.
Cost: $100.00 (shipped USPS Priority within the 48 included in price)
Current setup:
Note: For folks that are running the AutoTrickler V3 system, I also have the below design available, just with a different top.
Thanks,






Just finished up a new version for the AutoTrickler V4, if anyone is interested.
-------------------------------------
Update: I've done a minor tweak to the risers (thx for the idea Lawrence97) and have included an nylon adjustment thumb screw in the rear wing to allow tilt adjustment for your ATv4 trickler. While I do include a rubber bumper on the rear, you can pop this off. This should help prevent the need for shimming the unit to adjust the feed flow from the smaller trickler tube as mentioned in the manual.
Additionally, with some powders, I find that is your are using the Area 419 cup, the powder granules can sometime bounce out. I've worked up a little extension to push into the factory power nozzle that will help prevent that.
-------------------------------------
This version will only come as a enclosed version with removable doors like the V3 version.
Cost: $100.00 (shipped USPS Priority within the 48 included in price)
Current setup:
- AutoTricker v4
- A&D FX-120i Scale
- Base support for either the Factory Circular scale pan or the Area 419 triangle scale pan (just specify on request).
* If you have a different scale, just PM me and I can work with you on a base.
Note: For folks that are running the AutoTrickler V3 system, I also have the below design available, just with a different top.
Thanks,






Last edited: