AutoTrickler V4 question

[sgav8r]

So I’ve just ordered a 2nd ATV4 from MacDonald. I’ll have two of them side by side on my bench. I’m quite familiar with the operation of the ATV4 so I have no concerns about the setup, installation, use etc. The question I have is regarding the app. Does anyone else have experience running multiple ATV4 units in close proximity to each other? Does the app have parameters for distinguishing between multiple ATV4 units? I ask this because I know from experience that when connecting my existing V4 to the app it just basically says an ATV4 has been detected and connected, doesn’t really give any specific identifying info about that particular ATV4.

 

[David Christian]

I run several ATV3’s and when I load the app it shows all of them and I connect and manipulate each individually. Can’t imagine the v4’s operate differently. As an aside, each one displays a unique number code when connecting, so I have those generated numbers labeled on each machine to distinguish them from each other.

 

[sgav8r]

I run several ATV3’s and when I load the app it shows all of them and I connect and manipulate each individually. Can’t imagine the v4’s operate differently. As an aside, each one displays a unique number code when connecting, so I have those generated numbers labeled on each machine to distinguish them from each other.

Ok this is the answer I was hoping for. Only issue is, as it is now, when I connect to my singular V4 it doesn’t show anything identifying it from a possible other machine.

 

[madmixerman]

So I’ve just ordered a 2nd ATV4 from MacDonald. I’ll have two of them side by side on my bench. I’m quite familiar with the operation of the ATV4 so I have no concerns about the setup, installation, use etc. The question I have is regarding the app. Does anyone else have experience running multiple ATV4 units in close proximity to each other? Does the app have parameters for distinguishing between multiple ATV4 units? I ask this because I know from experience that when connecting my existing V4 to the app it just basically says an ATV4 has been detected and connected, doesn’t really give any specific identifying info about that particular ATV4.

That would be a good question to ask Adam. He is usually quick to respond.

 

[sgav8r]

That would be a good question to ask Adam. He is usually quick to respond.

Asked, and answered. Good call! And good info too.

 

[muleystalker]

Or you can use an old cell phone for one unit and your new phone or tablet for the other. Or your tablet of one and phone for the other. Just another option.