AR10/308 DPMS barrels? where and who

[constructor]

Is there anyone making finished 308AR barrels?
Krieger only makes 1 contour,too big) John at WOA is not.
Randall at AR barrels is not.
Mike Rock is too busy.

I'm looking for a cut rifled, 5R,that narrows it down a little)
18" HBAR profile, fluted, SS, 95 palma chamber,11-12" twist.
threaded 5/8-24 and rifle length gas system for a DPMS upper.
I know this is a BR forum but Does anyone know?

 

[ConnorExum]

Is there anyone making finished 308AR barrels?
Krieger only makes 1 contour,too big) John at WOA is not.
Randall at AR barrels is not.
Mike Rock is too busy.

I'm looking for a cut rifled, 5R,that narrows it down a little)
18" HBAR profile, fluted, SS, 95 palma chamber,11-12" twist.
threaded 5/8-24 and rifle length gas system for a DPMS upper.
I know this is a BR forum but Does anyone know?

What about Bartlin Barrels they do Five R Cut Rifled Barrels... Krieger won't do 5R last time I checked... But the Bartlin Guys used to work at Krieger.

 

[constructor]

Good to know. Thanks

 

[Bobs243Ackley]

I have a five groove, cut rifled, Satern 5C on my .22BR, and this barrel has really been shooting! It broke in easily at seven rounds, and is one of the easiest cleaning barrels I have ever used! I had this rifle out two weeks ago and it was averaging slightly above quarter inch at 100 yards with the 90gr. Sierra MK! It even spit out an occasional .189" to .195"! You can contact Satern at www.saternmachining.com for any questions that you might have.

Cordially,
Bob Blaine

 

[constructor]

Sounds good Bob. Who are the guys at Satern? What's their background?

 

[Bobs243Ackley]

The company is run by Steve & Deb Satern and they are great folks to deal with. Steve was with Berkly Tackle for many years in tool & die and when the opportunity was right, decided to take the shop from a part time operation to a full time operation. We have carried their funnels for some time and the quality has been very good. I have found that this attention to detail has been carried over to all of the products that they make, including the barrels. I had the pleasure of seeing how they make a cut rifled barrel. Did I ever have an education as to learning what to look for in a high quality barrel! These folks do everything in their shop! From cutting the bar stock, deep hole drilling, rifling, lapping, & contouring! I have a new respect for the folks who make the barrels that we take for granted. Get in contact with them, e-mail is the best way, and they will get in contact with you to discuss your needs as to what you need in your barrel. If my experience is an indicator, you will not be disappointed.

Cordially,
Bob Blaine