Anschutz 64 prone stock..leads??

[Jvance513]

I have an old 64 match single shot that I’m in need of a stock for. The current stock that I have was cut down for a kid. I’m into this rifle for the right price and it shoots extremely well and I’m wanting to find a factory prone stock for it. Any leads are appreciated!

 

[Bluefink4895]

With the 64 out of production that might be hard. I don't think the 1700 series is drop in compatible either.

Champions choice used to carry a variety of replacement stocks, but now all they show are 54 stocks and chassis.

Not what I would call a prone stock, but here is one: https://1022racerifle.com/boyds-at-one-adjustable-pepper-stock-anschutz-64-sa-tapered-barrel-rifle/

Possible sources:

Anschutz Replacement and Aftermarket Stocks

www.rimfirecentral.com

 

[Bluefink4895]

Here's a possibility (repeater stock though)

Anschutz 64 MP R Stock

Anschutz 64 MP R Stock

www.nordicmarksman.com

 

[Bluefink4895]

One more - used: http://www.hoosiergunworks.com/catalog/rifle_stocks.html

 

[Walt Krafft]

Another fix would be to add an adjustable buttplate assembly to the stock you have.

 

[Jvance513]

Another fix would be to add an adjustable buttplate assembly to the stock you have.

This may be the route I go with a RAD system

 

[Bill Rodolph]

I have an Anschutz prone stock for a model 54. Would require bedding and maybe some new holes, just a thought. I also have a left hand 3 position stock for a 64. It would require the bolt notch on the right side. Just another thought.

 

[fkimble@charter.net]

Walt beat me to it! Either a spacer or two or a recoil pad.

Frank

 

[akajun]

Another fix would be to add an adjustable buttplate assembly to the stock you have.

Yes this is the easy button

 

[kzin]

Boyds makes several inlet for A64

 

[kzin]

Anschutz 1903 Walnut - No Fittings

Anschutz 1903 Walnut - No Fittings

www.nordicmarksman.com

800 canadian just for the wood. yikes

 

[kzin]

I have an Anschutz prone stock for a model 54. Would require bedding and maybe some new holes, just a thought. I also have a left hand 3 position stock for a 64. It would require the bolt notch on the right side. Just another thought.

Lefty 3p stock probably has other problems for a RH besides the bolt.

 

[Jvance513]

This is the stock I’m looking for. Would really prefer a factory take off stock. I ordered a butt plate extension kit from SPS until I do find one.

 

[cbnky]

PM Sent