• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Am I on the right path to create 20VT brass?

I've been thinking about my "muffin top" experience. Based on the way mine looked, you'd think it was the result of the neck being pushed down and ballooning rather than

the unsized portion of the neck. I think the jump from .234 neck, created by my FL die, to a .226 neck by my neck sizing bushing die is too big of a reduction.


I'll sure be glad to finish moving to my new place so I can fully jump into this rather than my current piece meal fashion.
 
You must log in or register to reply here.

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
165,839
Messages
2,203,998
Members
79,148
Latest member
tsteinmetz

Share This Page

Back
Top