Aics mag cut single shot adapter/ follower

[Dusty Stevens]

anybody make one, like a mag follower that fits in the action cutout?

 

[teele1]

i have a single shot adapter made by CDI in Sarasota that fits my AICS bottom metal just fine if this is what you're referring to

http://www.cdiprecisiongunworksstore.com/single-shot-loading-blocks/

 

[Dub]

I use a Bob Sled. Got it from Brownells

 

[GenePoole]

I make these on my 3d-printer. Based on the dimensions of the "Bob-Sled."

 

[Papa Charlie]

I just use a Magpul 5 round mag and feed a single round at a time by dropping them on top of the mag. Works great and is very light in weight as well. I have contemplated removing the spring and internals and just gluing the follower in place which would make it a dummy and would reduce additional weight. I could even cut down the body more to make it sit flush with my mag well so I would not have to remove it between matches. It would just look like an empty mag well to the RSO.

 

[Dusty Stevens]

This is what im referring to for an action with a cut out

 

[Ledd Slinger]

View attachment 1103017

This is what im referring to for an action with a cut out

Those have to go on the under side of the mag feed rails so it would be the same difference in buying the suggested 'Bob Sled' I'd the DBM is still installed.

Unless you want a follower that inserts on an existing mag or plan on placing the action in a single shot stock? Then I would just make one on the mill. Would be easy enough.

 

[Dusty Stevens]

Its going in a stock without a cutout

 

[DaveTooley]

Dusty
A standard action with rails works with the single stack mags. Is your action cut for the double stack AI mags? No feed rails? If so it will take a custom made filler as I doubt anyone makes one.

 

[Dusty Stevens]

Dusty
A standard action with rails works with the single stack mags. Is your action cut for the double stack AI mags? No feed rails? If so it will take a custom made filler as I doubt anyone makes one.

Yes sir. Its a mausingfield so its doublestack cut

 

[jonkeil243]

Funny this thread, I was just looking myself for a single shot follower for aics mags. I did not know about Bob Sleds. Is there anyone else who makes these? One i would need they dont make or it was discontinued.

 

[Dusty Stevens]

Gene poole above can print you one

 

[jonkeil243]

Thank you Dusty

 

[jonkeil243]

I have tried Gene Pool above as well as the manufacturer to no avail.
Bob sled folks cant seem to wrap their head around there is different mag sizes even if sending information and links. Is there anyone else who makes these sled type single shot mag blocks??
Thanks

 

[GenePoole]

I've been kinda busy and must have missed your PM. I'll get back to you.

 

[jonkeil243]

Thanks you

 

[LGKLAS]

I make these on my 3d-printer. Based on the dimensions of the "Bob-Sled."

I have an FN PBR action and magazine fed bottom metal and 5 round magazine. Can you make one of these for my set up?

 

[GenePoole]

I know nothing about that action. Does it use standard (like AICS) magazines or something proprietary?