I’ve got a question about fitting action into the stock.l bought a Richard’s Microfit for a 10/22 99% inlet.l’ve got the action in the stock it fits pretty snug have to push it down pretty hard but it is bottomed out going to pillar bed front screw and use a Kidd rear tang bedded iit to tight or should it be fitted a little looser to get in and out.Thanks.
Action fitting
- Thread starter Clay bird
- Start date
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.