75 grain eldm

[kochie]

I’m having a custom bolt action build 22 CM just wondering about mag length if it be too long the 75 eldm not sure what gunsmith will use on this custom built maybe it won’t be a I'm not sure guess I will leave it up to the gunsmith

 

[venatic]

You will be fine with any short action magazine. You should load at around 2.610 OAL

 

[22vartarg]

Agree with venatic…. I run mine at 2.630 OAL with the 75 eldm.

 

[kochie]

Agree with venatic…. I run mine at 2.630 OAL with the 75 eldm.

Agree with venatic…. I run mine at 2.630 OAL with the 75 eldm.

Thanks guys one thing I haven’t payed much attention to is magazines over the years thanks again.

 

[kochie]

Thanks guys one thing I haven’t payed much attention to is magazines over the years thanks again.

How far off the lands does that put you guys?

 

[JPB3]

Reamers aren't standardized so throat length will vary...

 

[kochie]

Reamers aren't standardized so throat length will vary...

So if ordering a reamer order zero free bore & let gunsmith throat it out .

 

[urbanrifleman]

So if ordering a reamer order zero free bore & let gunsmith throat it out .

Manson standard 22 cm reamer is 70 fb. Just get that.

 

[kochie]

Manson standard 22 cm reamer is 70 fb. Just get that.

Ok thanks

 

[urbanrifleman]

Ok thanks

I shoot the 75 ELDM 20 into the lands from touch. One of my other customers who's a high master shooter also shoots approximately 20 jam

 

[kochie]

I shoot the 75 ELDM 20 into the lands from touch. One of my other customers who's a high master shooter also shoots approximately 20 jam

Ok thanks very much