This has to be a dumb question. I am having to pull about 20 115 dtacs with a forester Die because I discovered powder was bridging inside my 550 powder die with the black funnel attached. Now that I have done some research, it’s a common problem. My question is: Now that I have pulled the bullet and dumped the powder do I resize my necks? I am using bushing dies without a decap pin but should I do a full length resize with a primer in the pocket? I don’t have a neck size only die and don’t want to buy one...should I just see if there is enough tension left to seat bullets over the new load of powder?
Disgruntled
Disgruntled