Has anyone made 6xc brass from Lapua .243 or .308 brass.
If so what is the H20 capacity? I ran some Lapua through a 30BR, then a 6.5BR and then a 6BR die. The dies were shim to achieve the desired shoulder length. I made a case with a shoulder height of 1.435
height to neck junction 1.601
shoulder diameter of .461
neck length of .330
oal case length of 1.930
web diameter of .470
shoulder angle 30
When measuring the h20 cap. to overflow does that mean level with case mouth or with a bubble on top.
I came up with 49.0 grains with a bubble on top.
I know there is a lot of knowledge on this site
Thanks.
If so what is the H20 capacity? I ran some Lapua through a 30BR, then a 6.5BR and then a 6BR die. The dies were shim to achieve the desired shoulder length. I made a case with a shoulder height of 1.435
height to neck junction 1.601
shoulder diameter of .461
neck length of .330
oal case length of 1.930
web diameter of .470
shoulder angle 30
When measuring the h20 cap. to overflow does that mean level with case mouth or with a bubble on top.
I came up with 49.0 grains with a bubble on top.
I know there is a lot of knowledge on this site
Thanks.
