6mmbr die question

[Ktmracer358]

You need to ensure that the dies are for Norma also ensure that a small decap pin is installed. Forster microseater will work well if your not ready for Wilson and Arbor press in addition before you can get a Harrell's FL die you will need to Fire form your brass at least 3x that will require at minimum neck sizing 2x I use a $40.00 Forster. There's a few more subtle things to get by if choose to go 6 BR
Anyone on this forum will help.
Regards
SPJ

Thank you

 

[Toby Bradshaw]

before you can get a Harrell's FL die you will need to Fire form your brass at least 3x that will require at minimum neck sizing 2x I use a $40.00 Forster.

You don't need to size the brass to produce a 3x fired case. Just put the bullet into the charged/primed case by hand, be careful not to let the bullet fall out when you chamber the round, and pull the trigger. I've ordered several Harrell's FL bushing dies using 3x fired cases produced by this method.

 

[JFrank]

You don't need to size the brass to produce a 3x fired case. Just put the bullet into the charged/primed case by hand, be careful not to let the bullet fall out when you chamber the round, and pull the trigger. I've ordered several Harrell's FL bushing dies using 3x fired cases produce by this method.

Really?
That never crossed my mind.
J
I'm have to say thats pretty ingenious '

 

[Toby Bradshaw]

Really?
That never crossed my mind.
J
I'm have to say thats pretty ingenious '

Thanks, but I'm afraid that being lazy and cheap are the real explanation.

 

[boltman13]

I decap with a Sinclair small stem die, resize with a Forester Shoulder Bump Bushing Die and seat bullets with a Wilson Micrometer. Works for me.