6mm Rem build Chamber, thread?

[Glocksig]

Hi all,

I'm going to build a 6mm Rem on a 700 action and was looking for some reccommnedations on who to use for chambering/threading. I'm planning on putting a Schneider barrel on it. I'm in Virginia so Clay Spencer was my first choice but I hear he's backed up a good 8 months. Any suggestions?

Thanks

 

[Preacher]

Seems most all the good ones are backed up as usual...
Clay does good work so I would just get in line and wait
if I wanted him to do it...

 

[tightneck]

Wayne Shaw...send him a pm. He will get you done in short order and his chambers will shoot as good as any. He's located near Winchester.

 

[357Mag]

Sig -

James Peightal of Ernest, PA.

DonLewis writes about Peightal's work in "Precision Shooter"
magazine, all the time.

Great metal work, superb accuracy results, comparativley low fees; and fast turn-around times

Best of luck in your endeavors.

Regards,
KJW

 

[Glocksig]

Thanks for the suggestions, I've got quite a few good ones.