Hi all,
I am looking to get a reamer for my dasher. I dont have the specs of the current chamber...nor can i get them now,long story!)
I use lapua brass,clean up turned only) with a loaded OD of .270" using 107 SMK's. These chamber quite easilly with no problems. Would a neck dimension of .272" on the reamer,ie .001" clearance) be suitable? I have read a little about this on other posts but I'm not sure what is suitable or not. Any opinions are appreciated.
This is an F-Class rifle
I am looking to get a reamer for my dasher. I dont have the specs of the current chamber...nor can i get them now,long story!)
I use lapua brass,clean up turned only) with a loaded OD of .270" using 107 SMK's. These chamber quite easilly with no problems. Would a neck dimension of .272" on the reamer,ie .001" clearance) be suitable? I have read a little about this on other posts but I'm not sure what is suitable or not. Any opinions are appreciated.
This is an F-Class rifle
