I don’t follow why would you judge a bushing from a fired round ?Run your expander ball through some brass to keep them round, Load for break in, pressure range data and measure your fired necks and go from there.
What size bushing are u guys using for lapua 6br brass?
I'm thing about getting a carbide one once I find where my dies are in storage.
Not to judge for bushing size, when robbor stated "no turn, not sure" It would be a good time to see if it is on the tight side or loose side for clearance. I didn't know if robbor meant not sure if he was going to turn necks or not sure of his neck diameter, either way good time to get a little data. I also like to put a bullet in a fired case and see what the clearance feels like, light grab, loose, snug etc.I don’t follow why would you judge a bushing from a fired round ?
Just curious
Got it’ thx I was trying to figure out something similar once, but I got side tracked IIRC.Not to judge for bushing size, when robbor stated "no turn, not sure" It would be a good time to see if it is on the tight side or loose side for clearance. I didn't know if robbor meant not sure if he was going to turn necks or not sure of his neck diameter, either way good time to get a little data. I also like to put a bullet in a fired case and see what the clearance feels like, light grab, loose, snug etc.