6 Dasher With 103 VT-TAC reamer

[Ajwilly96]

I’m looking to have a reamer designed for a 6 Dasher tight neck to shoot 103 VT-TAC bullets.

I’ve done some research and found that some people say these bullets like jam and some jump. Being that I’m getting a custom reamer for these bullets I was wondering if anyone has recommendations on what FB to get with this reamer?

Also is there any spec on a standard reamer that you would change on a custom reamer?

This is going to be a build that is about a year out so I will probably wait for Lapua brass, but may end up with alpha.

This is going to be for a single shot XP-100

 

[Gabe22BR]

Pass on turning necks for nothing-…. No need in it..

95-104FB all needed
If going for hybrids or 108vld-.120” get ya there…


Just my experience

 

[quest450]

the gentleman who designed and makes the bullet might know

 

[Ccrider]

Watching.

 

[LRPV]

I tried to send you a PM but for some reason I can't send them anymore, just get an error message. I can usually reply though. Send me a PM and I'll try to help.