6 Dasher H4350 Load Development?

[HTSmith]

Before I went much further I'd load one at 34.5 grains .006" past first touch (into the lands) and check for pressure and velocity. Back off a bit if needed to be around 2950 fps.

If that works I would do 3-shot groups .006" IN, .015" out, and .020" out.

Honestly, I don't think the one shot ladders are particularly useful. Good barrels with a Dasher will probably shoot well at a variety of powder charges.

There are a lot of people who have won a lot of matches with 105-108s moderately in the lands at around 2950 fps. I am presuming you have a quality barrel.

I'll give that a go. It is a Brux bbl. I just set the bullet .015" out or off arbitrarily. thx

 

[rogina]

I'll give that a go. It is a Brux bbl. I just set the bullet .015" out or off arbitrarily. thx

My 6 dasher likes 105 jlk's, 35.6 grains of h4350 with 450 primers Bullet into lands .009 Kreiger 1 in 8 twist. 104 freebore. 36 grains was too hot. I shoot at 3300 ft elevation.

 

[Dusty Stevens]

Thanks!!

Get in touch with one of your fellow bamashooters named johnnie webb. Hes up in guin and is the purveyor of those plates

 

[1bamashooter]

Get in touch with one of your fellow bamashooters named johnnie webb. Hes up in guin and is the purveyor of those plates

Will do thanks Dusty!

 

[KMart]

My 6 dasher likes 105 jlk's, 35.6 grains of h4350 with 450 primers Bullet into lands .009 Kreiger 1 in 8 twist. 104 freebore. 36 grains was too hot. I shoot at 3300 ft elevation.

35.6 was where my rifle shot well using 4350, but with the 105 VLDH