6.5x47 Lapua Dies Redding Part #'s

[457ciSBC]

Here's the part #'s, lead time is 1-2 months

S FL- 77590
S Neck- 71590
Body- 75590
Comp Seater- 55590

Also Forster will be making dies as well, a reg FL and a Comp set, lead time TBD.

Mike

 

[Forum Boss]

Mike, thanks for the info.

FYI, for those considering a Forster FL,non-bushing die) keep in mind that for $10 plus sh/h, Forster will hone the die to the neck diameter you specify. This is a very nice solution that sizes the whole neck very consistently. Of course you loose control over neck tension, but if you're running no-turn brass I find I get very consistent tension this way with a .267-honed neck for the 6mmBR.

 

[Wild_Bill]

If you are using it in 6mm the 6mm BR comp seater and neck die work perfectly backed up a bit but the Type S Full length die with a 269 bushing should be a great place to start.

Cheers Bill
Australia

 

[CAB]

I spoke with Forster on the 12th, and they seemed very sure they would have both the 6.5mm and the 6mm versions done, and in my hands by the time Camp Perry starts. They have the reamer prints from Kiff and the CIP prints from Europe.They are in process as I write this,......

Chris
Graf and Sons

 

[457ciSBC]

Here's the part #'s, lead time is 1-2 months

S FL- 77590
S Neck- 71590
Body- 75590
Comp Seater- 55590

Also Forster will be making dies as well, a reg FL and a Comp set, lead time TBD.

Mike

FYI