6.5-06 A Square which go gauge?

[btrapr]

I know to some this seems like a dumb Q?, but I ran across a 6.5-06 A Square PTG solid pilot reamer...No paperwork...

From looking at dimensions for a 25-06, 270, and 30-06 the length from the shell base to the joint of the neck/shoulder,where they some together) are different in length...Noslers reloading book also shows the following numbers for those areas; 25-06 is 2.186", .270 Win is 2.156", 30-06 is 2.109". They also show a 6.5-06 but they do not say who's chamber 2.175"...SECONDLY when you neck to or up to make the brass will this measurement change? and does that allow the use of another Go Guage other then a 6.5-06 A Square?

Do I need a 6.5-06 Go Gage or can I use one for either a 25-06 or a 30-06???

Thanks,
New_Guy

 

[Spotcheck_Billy]

Why don't you ask Dave Kiff ar PT&G?

541-826-5808 or pacpes@medford.net

 

[btrapr]

Thanks for the input...I was going to order some stuff today and thought I would throw in the gauge with it so I am closer to getting all my stuff together. Tomorrow is a holiday so I'll have to wait until Tuesday to call.