looks like the NEO only goes to about 3.75 width of the front bag for the fore end of a stock for 600 or 1000 yards or so with the factory 3 piece bag.
rather than thin the stock down to 3.70 finished (resale drop and want to use other guns with a 4 inch fore end for long range at a bench)
should I thin the inside (bag side) of each of the 2 round columns and perhaps thin the side bags a little to get the full 4 inches of the stock to fit the bags,
maybe with a little less sand I might not have to thin the columns?
any experience in this as I would also like to keep the NEO stock and not modified, anybody else get a 4 inch stock to rife in the front bag without modification other than the sand fill level
simple enough I just do not have the time to try it right now not at home for a week, and I like how it is set for BR guns now
Jefferson
rather than thin the stock down to 3.70 finished (resale drop and want to use other guns with a 4 inch fore end for long range at a bench)
should I thin the inside (bag side) of each of the 2 round columns and perhaps thin the side bags a little to get the full 4 inches of the stock to fit the bags,
maybe with a little less sand I might not have to thin the columns?
any experience in this as I would also like to keep the NEO stock and not modified, anybody else get a 4 inch stock to rife in the front bag without modification other than the sand fill level
simple enough I just do not have the time to try it right now not at home for a week, and I like how it is set for BR guns now
Jefferson