38 Super, 40S&W, 400corbon/45ACP and scale problems.

[cimarronvalley]

Does anyone have any pet loads for 38super, 40S&W, 400corbon, and 45ACP?
Also, I have an RCBS electronic scale/dispenser system,Chargemaster 1500). When using Alli ant and Accurate pistol powders,Power Pistol, Bulls eye, BlueDot,No.5, No.9,etc) the flake powder coats on the internal plastic within a couple of hours. Since I load several hundred rounds per event, it takes several hours. By the time I'm done, the powder scaling completely covers the plastic. I clean it using alcohol and stiff brushes and it takes about an hour to clean. I then dry it in front of a fan to evaporate the alcohol. My biggest worry is that the liquid cleaning may hurt the internal parts for the dispenser system. I emailed RCBS twice and have yet to receive a response.
I use a Hornady Pro-Jector progressive press and I have the same problems with these powders in the Hornady automatic powder dispenser. And it has a metal funnel base.
I just started reloading again last year after a 20+ year hiatus. I don't remember these powder interactions from previous experience. Does anybody else have these problems? Is there a coating that can be applied to the dispensers? Any input is greatly appreciated.

 

[Winchester69]

Regarding your static problem, another forum recently had an extended discussion of this problem. To summarize, the common solution is to wipe down the equipment with a clothes dryer anti-static sheet before use. Someone also introduced a solution of using a paper clip attached to the body of the reservoir that acts to concentrate the static charge and bleed it off to atmosphere. A more formal means is to ground the equipment,bonding).

You will get better response to your request for load recommendations by stating bullet type, and desired velocity or application.

 

[cimarronvalley]

Thanks Winchester69. Something I wouldn't of thought of. I'll give it a try.

 

[AndrewB]

http://www.k8nd.com/ipscload.htm

Try the link above for loads