300 WSM Lapua Brass

[dkhunt14]

There is a thread on this forum from a guy that works for Lapua. I put-on a post about 300 WSM brass. Maybe if enough guys post on there, he will read it. Maybe by some chance it would help convince them to make it. What could it hurt to post something. Sooner or later they might get it. It is the thread about VithtaVuori powder. Matt

 

[JRS]

Kevin Thomas addressed that, along with the Dasher and 284 Winchester brass, long ago.

 

[dkhunt14]

Kevin Thomas addressed that, along with the Dasher and 284 Winchester brass, long ago.

I have talked to some of the Lpaua Reps. I have private messaged Kevin and talked to jack Neery in person a couple of times. This guy is higher up the totem pole. Maybe it will get some results. Matt

 

[Joe Salt]

Like they always say, your preaching to the choir! There the ones losing out.

Joe Salt

 

[dmoran]

Of all the 30-caliber hunting guns I have worked on or with, the 300-WSM has became very popular the last 10-years.
Through my shop I will estimate 3 out of every 5 are 300-WSM's. Hardly get any belted-case magnums any more.
It's a no-brainer to me, that 300-WSM brass is in high demand in my area of the country.

With that said, Lapua hear me roar; " We want you "
Donovan Moran

 

[KevinThomas]

I hear ya' guys. We'll be headed to the SHOT show in Vegas in the next week or so, and the upper management folks from Finland will be there. We'll be going over to Germany for the IWA show in March, so that's another chance to chat with them again. Trust me, Adam and I will be bending their ears at both.

 

[Joe Salt]

Kevin can you adopt me and take me with you? Promise i'll be good.

Joe Salt

 

[Geno C]

I'll join the group of shooters that would jump on the Lapua wsm brass

 

[th82457]

I'll join the group of shooters that would jump on the Lapua wsm brass

+ me on that

 

[whatwind?]

+ me on that

+2

 

[pikespeakgoat]

If this would ever happen, it would be the cats meow!

 

[Scott Harris]

If this would ever happen, it would be the cats meow!

+1

 

[rickiesrevenge]

I'd buy them. I'd also like to see 404 Jeff brass to form RUM, dakota, etc off of.

Aaron

 

[dkhunt14]

If they decide to do it, they better make a big run. It would sell really fast. Matt

 

[dbramley]

I would be in for some

 

[ebb]

I would have built a 300WSM a long time ago if there was Lapua brass for it.

 

[Wildcats]

My mind is going 240mph just thinking of the wildcats i would make from that alone.

 

[dmoran]

My mind is going 240mph just thinking of the wildcats i would make from that alone.

+++ 1

 

[johnfred1965]

+++ 1

Sometimes I think no matter how much you ask, Lapua has it's own time line. I inquired for years about 260 brass, but finally gave up and built a 6.5x47, then 260 came out. Same thing with 20vartarg from 221 fireball brass, I started with norma until Lapua came through. Finally, I always equated Lapua with accurate match calibers, when they started making 300BLK I wondered if that caliber really needs such fine brass or if they were just jumping on the bandwagon. I'm guessing the latter. Don't want to give them too much of a hard time though, I won't buy anything else if they have the cartridge I need.

 

[ab_bentley]

I'd be good for a few hundred.

That 6.5-300wsm would be awesome with the "L" headstand.

Adam