WANTED 25-06 brass

[kyotekiller25]

What's out there for quality 25-06 brass? I'm looking for 100 pieces for a new 6.5/06 AI

Norma, Nosler, or Winchester (blue bag) preferably in that order.

Thanks!

 

[topclass2017]

I have 2 (red) bags of 50 Winchester that are excess to my needs

 

[Kracken McGraw]

Would 270 brass work?

 

[brad6ppc]

I have a bunch of older unfired Winchester.

 

[kyotekiller25]

Would 270 brass work?

It would, but I think it's just easier to neck up from 257 to 264, than it is down from 277 to 264, and you don't end up with such a long neck that needs trimmed.

 

[Kracken McGraw]

It would, but I think it's just easier to neck up from 257 to 264, than it is down from 277 to 264, and you don't end up with such a long neck that needs trimmed.

I see, I didn’t know how it worked for the AI type cases. Usually necking down is preferable from what I have seen here.
3rd Generation has a bunch of of old stock Winchester 270 brass

 

[kyotekiller25]

I see, I didn’t know how it worked for the AI type cases. Usually necking down is preferable from what I have seen here.
3rd Generation has a bunch of of old stock Winchester 270 brass

Heck it might be. I could be wrong. I'm not super experienced with AI's myself. This is only my 2nd one. My other is a 6 BRA, which doesn't require necking down or up.

 

[Kracken McGraw]

Heck it might be. I could be wrong. I'm not super experienced with AI's myself. This is only my 2nd one. My other is a 6 BRA, which doesn't require necking down or up.

https://store.thirdgenerationshootingsupply.com/brass/270-winchester
Here’s the brass.

 

[17VLD]

I haven't tried the Starline stuff in 25-06 yet but have been favorably impressed with the 222 brass they offer.
The OP only wanted 100pcs but perhaps he has a friend that could split an order of 260 @ $163-
If they ever choose to make .220 Swift or 218 Bee I'll buy it by the thousands.
Matt

 

[SBS]

Using .25-06 is the easy way, but you will wind up with short cases after fire forming -- it uses up some length to blow out the taper and form the 40 degree shoulder. .270 will probably require some trimming, but will be long enough. If you want high quality brass, Lapua .30-06 brass is the way to go, but requires turning necks.