22Nosler in a Bolt Gun?

[jfseaman]

Care to share that "Rim turner" idea?

I will have scratch my head a bit and draw it up.

I have a lathe so the "best" rim turner would be a pot collet reamed with either a chamber reamer or sizing reamer so the rim is proud. Then make a shaping tool.

A "manual" tool say something that could run on a Foster trimmer or similar lathe style trimmer will take a little more thought and engineering. My concept is still very similar. Make a collet that fits the case shoulder, a shaper tool. Feed via a lever and stop.

I'm working on a broken 6-48 tap, some 257 Roberts Black Powder Only cases, a Hydro die for 375HE, resize die for 375HE, Rebarrling my BIG action with the 375 Barrel and opening the bold face from RUM to CheyTac/HE.

I should have the rim turner done in a couple hours.

 

[Bully]

I will have scratch my head a bit and draw it up.

I should have the rim turner done in a couple hours.

If/when you get to it, I'd love to see it. Sounds interesting if not a bit above my pay grade.

 

[gopherslayer]

The other calibers you mentioned have the wrong bolt face. This will be in a bolt gun, so the AR mag issue is moot as I'll be running AI mags. I don't want to open the bolt face.

You mentioned the AR mags in your first post.

 

[Bully]

You mentioned the AR mags in your first post.

Ah. Gotcha.

I was considering using the PT&G bottom metal that accepts AR mags. That way I could run 6.8SPC mags in the rifle. I did a bit of research and the bottom metal that takes AR magazines is a different pattern than my stock inlet.