• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

22 Waldog

Hammer47

I suffer fools poorly.
As we all know this is only a 22 PPC .125 short. Anyone have a clue as to a "trim to" length? Great loads would be appreciated too. Gary
 
If you have a trim die or a Wilson case holder mount it in a press or vise. Put a fine tooth blade in a hacksaw and with one swift, cut to rough length. Than finish to final length with your trimmer.

Some guys get a small power cutoff tool from Harbor Freight and rig up a wood holder. Check utube .

Hal
 
Made a wood block fixture with rabbeted slot and positioning stop for use with mitre cross slide on my 10" cabinet saw (fitted with 80 tooth carbide blade). Very fast with nice clean repeatable cut ---- elevate blade height just enough and know where your "fingers" are at all times!
 
You misunderstand me fellas, I am after the length dimension like 1.125 inches for example.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,224
Messages
2,214,373
Members
79,485
Latest member
bhcapell
Back
Top