20. tactial casses

[bjweek]

can any one tell me the case lenght of the case for a 20.tactial.

 

[garyw]

bj i trim my cases to 1.750 from lapua 223 brass using redding bushing dies.i know some folks leave them longer to 1.755/1.760 but i found this trim length works well for me.
gary w

 

[bjweek]

can you tell me what size bushing to use on this gun. i'm haveing the reamer made with a .237 neck on it ...

 

[garyw]

bj my loaded rounds are .233[32 vmax] using a .227 bushing inside of necks lightly lubed; fired necks are.235 i think you will be ok with a bushing about the same .my necks are not turned gun is a dakota predator i dont know reamer size used got the dies from TODD KINDLER WOOD CHUCK DEN.he sent the bushing with the dies this has produced very accurate rounds 3 shots always under .300.check with your smith though about the bushing needed.

garyw

 

[bjweek]

can anyone tell me the reloading data on the 20 tactial ??????

 

[Phasor]

Go to the 20 cal page on this site. There is load data there for the 20 Tactical.

Phasor

 

[bjweek]

can any one tell if it is safe to use Reloader 10X with a 4-gr vmax????? all thats on here is Reloader 10X with a 32gr vamx i just wanted to know if it was safe..

 

[garyw]

bjweek in my tact 20 rel 10- 24.8 gns 40 vmax 5 shots always group under 1/2in @ 100yds.
40 berger 24.5 rel 10 again under 1/2in @ 100yds best ten shot group with this load .632in these bullets are very accurate but i shoot fox over here in the uk i find the v maxs more explosive.
have you tried the 39 sierras these are very accurate same load as the 40s.
anyways yes is the answer to your question rel 10 is very good in the 20s.have you tried vit-133 this is on par with rel 10 with a little more velocity.
as always start low with your loads and work up.
good luck keep us posted on your results.
garyw.

 

[bjweek]

does anyone know of a load for 20tac using h4198 with a 40gr bullet.