10-10 Issues

[bootlaceb]

Hi All
I have been getting irregular readings from my 10-10 scale lately. When I measure up a load, I trickle the powder bit by bit till it reaches the centre marks...as usual.
Well..now I get the the centre marks to corrospond, then I push the beam down, and let it settle again. 9/10 times, the beam centre is about 3mm above the centre line!!!
Any ideas how to solve this??
This is affecting my SD at long distances

 

[CJ6]

contact RCBS, It's most likely the anvil bearings are bad. If their customer service is what it was when I last used it they will ship the bearings free. great people

 

[JRS]

For a repeatable 10-10 scale, might I recommend sending it to Scott Parker. I can't tell you what kind of magic he works into these scales, but, suffice it to say, it is kernel repeatable time after time.