• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Bipod Positioning

james

Gold $$ Contributor
I have a question related to bipod positioning when shooting my Seekins Bravo 6.5 CM. I shoot my Seekins in competitions where we shoot off a concrete bench. I always thought it a good idea to try and place the bipod back in the same position each time by placing it against a 20 pound bag of shot. I use a Harris bipod with a set of Pod Paws which have a rubber bottom. I recently experimented with positioning it against the bag of shot and not worrying about position and there doesn't seem to be any difference between how it shoots. Am I wasting my time packing around the bag of shot?

Thanks!
 
I read an article some years back, a guy named FROGGY wrote it, the name of the article, if I am remebering correctly, was titled, Bugholes From Bipods, A very good article where he highly reccommends "preloading" the bipod by pushing against a barrier or heavy bag before firing.
Good article!
 
Load, no load, don’t matter at all.

What matters is that you find something comfortable for yourself and do it the same way, with the same amount of shoulder and cheek pressure, every time.

For almost everything I shoot, I like to pull the rifle back into my shoulder with my shooting hand, zero in on the bull and release hand pressure. That’ll have the butt of the rifle touching your shirt but not your shoulder. Free recoil, more or less.

For larger calibers, I apply some shoulder pressure. Enough that I can see my breathing in the scope but not enough that I’m putting weight on the gun. It’s not really a “load” but it does take the slack out.
 
I've tested Bipod Forward, Bipod Rearward, loaded, unloaded
I still seem to shoot the same.
--
What I have found that is most important is
that the bipod legs not be put in a twisting type torsion such as if you pivoted the rifle on the bipod
which would make one leg loaded and the other leg in spring tension.
Before making a precision shot - I will lift one side to allow both legs to be at full extension from the springs and relieve any torsion
---
I mostly hold and control the gun.... and the bipod merely helps give me stability
yet with torsion (twist) in the bipod legs, seems to throw the shots off more than anything
 
The idea of front loading the bipod legs is to give them purchase against the surface they are on to prevent them from hopping from recoil which moves the barrel up and would potentially raise the POI.

If your bipod is hopping, then it might help in eliminating a stray round.
If you don't measure all your groups and don't keep good records, you'll never know if it really works or not.

For me, I found there was a slight improvement in the consistency of my groups. But I am accuracy anal and measure all my groups, so I could measure the difference by comparing before front loading and after front loading over a pretty large sample.

Since 2010, I use a Sinclair F-Class bipod that is very stable, and slides backward just like the rifle. It doesn't hop so I don't bother about front loading the bipod,
 
If I were shooting your setup, I would load it. If you don't want to carry a weight to put on the bench, put a retchet strap around it and load into it. There are most likely better options, but I have done this, and it has worked fine for me.

Regards
Rick
 
If you shoot enough different rifles and experiment with them, you will find that what they like to shoot their best can vary. Whether its accomplished by loading the bipod or pulling back against your shoulder, shoulder pressure matters in my experience. In general, lighter calibers like lighter shoulder pressure. Heavier calibers tend to prefer more shoulder pressure.

Rifle weight matters too. Heavier rifles are more forgiving. Lighter rifles can be very sensitive to shoulder pressure and the lighter the rifle the lighter the shoulder pressure in my experience.

I cant see needing a sand bag to load against unless its a rifle with some stout primary recoil. Even then, pulling back (which is easier to do on the bench than prone) can eliminate the need to load excessively.
 
Depends on the bipod. Each one is a bit different. I've found loading an Atlas or a Warne isn't as important as a Harris or similar style. I like to give it just a touch of forward pressure, but each spring I have to fine tune the pressure.
 
I remember asking this question and I got six different opinions that nobody agreed on.

Of course , they all assured me that their way was the very best way.

I think The conclusion from that is , find what works for you and don't worry about what works for anybody else. The target will tell you the answer to your question.
 
I remember asking this question and I got six different opinions that nobody agreed on.

Of course , they all assured me that their way was the very best way.

I think The conclusion from that is , find what works for you and don't worry about what works for anybody else. The target will tell you the answer to your question.
Find what YOU can duplicate every shot.
 
I finally learned how to shoot off a bipod the same way I shoot off a rest 100% concentration. those days I don't have it then I don't shoot good... pretty simple
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
168,943
Messages
2,265,373
Members
81,648
Latest member
dburr26
Back
Top