Do it yourself Stock making thread

[joshb]

And it only took about 20 minutes

That’s because you’re multi talented. Maybe you’re TRANS talented and identified as a woodworker for that 20 minutes? What would your pronouns be? I’ve been out in the sun. I need fluids!

 

[Bc'z]

That’s because you’re multi talented. Maybe you’re TRANS talented and identified as a woodworker for that 20 minutes? What would your pronouns be? I’ve been out in the sun. I need fluids!

Me
Myself
I

 

[ChristianSilver]

Are the lams perhaps warped? Something looks funny here.View attachment 1709696

I have since resurfaced my jig for holding the blank. When you're working with a CNC and a blank that's 40" X axis, 6" Y axis and 3.050" Z height and off a fraction over 40" make a big difference on either end. Definitely not warped... It will shoot a bunch of cleans,
Forend meet your approval?

 

[Jonnyofalltrades]

I have since resurfaced my jig for holding the blank. When you're working with a CNC and a blank that's 40" X axis, 6" Y axis and 3.050" Z height and off a fraction over 40" make a big difference on either end. Definitely not warped... It will shoot a bunch of cleans,View attachment 1709751
Forend meet your approval?

Haha! Most definitely meets my approval.
It's a beautiful stock, and I certainly wasn't meaninging to cast shade on your work.
My apologies.
I have made a few stocks myself, and yes, keeping everything inside the Iines is very difficult.

 

[Jonnyofalltrades]

Anytime I feel bad about my stockwork, I look at this beauty.
Bubba truly reached new levels with this one!

 

[ChristianSilver]

Haha! Most definitely meets my approval.
It's a beautiful stock, and I certainly wasn't meaninging to cast shade on your work.
My apologies.
I have made a few stocks myself, and yes, keeping everything inside the Iines is very difficult.

Honestly was just kidding, poking the bear..

It’s finishing out very nice, got it sealed today and will sand and clear tomorrow.

 

[Sniperhandle]

Dima modification....View attachment 1709666View attachment 1709667tools used, templates made with 1.5" tapeView attachment 1709669now to tear it down and strip the old finish.

It's not the "Arrow" It's the "Indian"

 

[joshb]

It's not the "Arrow" It's the "Indian"

Life’s too short to shoot an ugly gun!