vudu bolt/ bullet hitting side of chamber question

[rockwind1]

has anyone watched the bolt of their vudu push the cartridge off the mag and into the chamber? does it go into the chamber perfectly straight?

so when the bolt in my vudu picks up the cartridge, as i push it forward, the next cartridge under it pushs upwards on the cartridge the bolt is pushing into the chamber and the cartridge is now perfectly horizontal but about 2mm out of center of the chamber. it still slides in but the lead nose of the bullet totally hits the side of the hole. am i being too picky, i though the whole point of a very precision 22 was the round shouldn't be gnarled by the side of the chamber?

now if i remove the mag after the bolt picks up the round,, the round slides into the chamber perfectly.

it must be said, gun works fine.

 

[slobhunter2]

Have you tried to loosen the action bolts, then insert the mag, then tighten the action bolts?

 

[rockwind1]

Have you tried to loosen the action bolts, then insert the mag, then tighten the action bolts?

hmmm, not really. is that a normal thing to do? i had taken to lapua test center in phoenix a while back,, they took barreled action of out stock, did the test, then put back in. I think he had done it like a million times. i mean,, i am not thinking that is what is causing this,, for all i know, this could be totally normal.

 

[slobhunter2]

In one of the videos it was recommended, as well as standing it on the butt plate to bottom the recoil lug.