Todd developed the reamer with JGS to work especially with the new Lapua .221 Fireball.Being a sub-caliber chambering developed by the man I’d assume the “TK” would mean Todd Kindler but it sounds like you did the build yourself. What’s TK mean?
Cool! What’s the barrel length?Love to see your 20VT XP-100 pistol when you get it done. I've had several 20 VT rifles through the years. Attached is my XP-100 20 VT pistol. One of my favorite GS rigs. Lotsa GS kills out to 400 yds and slightly further. Hard to believe that a pistol will do that...but they do! Only thing better is my XP-100 pistol in 20 Javelina Improved. About another 100 yds range...Lol!! Very nice job on the rifle build. 7315br
View attachment 1388166
I’m getting around to sharing this. This was shot with subject rifle. Apparently @ 400 yds the little 20 VT looses it’s explosive effect.
PM sent.How much you want for it?
Did you post the correct reamer print for 221 Lapua brass formed to 20 vartarg with no turning?
LTR your Lapua brass is the thinnest necks ive seen, the ones ive measured have all been .2305-.231 loaded round.
That looks like my print! It works wonderfully for Lapua brass and 40gn on up bullets.LTR,
I just wondered as there is no mention of Lapua brass on the print.
If I remember right, my loaded rounds came out .231 to .2315 (maybe faulty memory). Been a while, and I don't use Lapua anymore for my vartarg.
Other than a few having EXP (experimental) the prints for Lapua brass usually state so on print.
Others also have any where from .234 to .255 necks for Lapua brass.
The print looks to be a fine fit.
I did notice a longer neck dim?
View attachment 1388685