Eldm vs matchburners

[pitbull]

I have 2 6.5x47s I have always shot sirreas 123 in one and 130tmk in the other. Getting low of both can only find 2 projectiles that seem to be alav match burners and eldm. Has anyone used these in there 6.5 x 47s. I am going to shoot silhouettes at 450 to 600 with some friends. Love to hear the good and the bad of each. More than likely I am going to buy each but just curious what everyone else thinks of the 2. Thanks

 

[Dusty Stevens]

I think for silhouettes either one will work fine

 

[pitbull]

I think for silhouettes either one will work fine

Which one you have the most luck out of

 

[Old Navy]

I have shot a bunch of the 140 and 147 ELD-Ms They will be well below the neck/shoulder junction.

 

[Dusty Stevens]

Which one you have the most luck out of

Eld

 

[Ranger188]

You can usually find the Hornady's easier than others.
For shooting steel @600 and less, go for the eldm's
You are not pushing them hard.
Cheaper too.

Hornady .264 Diameter 130 Grain Polymer Tip ELD Match 100 Count Bullets

Hornady .264 / 6.5mm 130 Grain ELD-M (Extremely Low Drag Match) (100)

www.powdervalleyinc.com

 

[Fuj]

Match burners are hit and miss to buy sometimes, but my findings
in 7mm gave the edge to Barnes.

 

[MUP]

I shoot the 140 ELD-Ms in my 6.5 CM out to 1000 and they shoot good. Regularly under .5 MOA at 600.

 

[boltman13]

I have had generally good results at 600 yds. in F-Class with weight sorted 140 gr. Match Burners in 6.5 Creedmoor. They should do OK shooting steel. I have personally seen factory ELD-Ms blow up in a 6.5X47.